Product Description
This fully 3D-printed hard case is made for the Happymodel Mobula 8 with the standard 85mm frame. It's the Elite version of our Mobula8 case, with a stronger latch, an 8-segment hinge, and storage compartments in the bottom with hinged lids.
The battery clips are sized for packs about 13 x 17 mm, like GNB 530mAh 2S. Fit can vary by brand, and any packs that don't clip in still fit in the storage compartments underneath.
A piece of filament is used within the hinge, eliminating the need for extra hardware, keeping the build simple, durable, and easy to repair. The battery clips slide into place with a friction fit, and the latch presses in from the top.
A tip on the battery clips. They slide in and out on purpose, so you can arrange them around whatever packs you fly. That also means they can sit a little loose at first. Once you land on a layout you like, one drop of super glue per clip locks it in for good. Just wait until you have settled on your configuration before you glue.
Compatibility
- Fits the Happymodel Mobula 8 (85mm).
- If you have the DJI O3 version, you may need to leave out the front and rear battery clips to make it fit.
- Flying the 80mm M8 Freestyle, also sold as the Mobula8 Freestyle? It takes a different shelf, so pick the Mobula8 Freestyle Drone Case (Elite) instead.
- The drone, batteries, and charger are not included. This is the case only.
Flying Something Else?
We print cases for a whole lineup of tiny whoops. Pick your drone and see every case that fits it.
